Maintenance; Troubleshooting - Life Gear 91201 Owner's Manual

Magnetic elliptical climber machine
Table of Contents

Advertisement

MAINTENANCE

Cleaning
The climber machine can be cleaned with a soft clean damp cloth. Do not use abrasives or
solvents on plastic parts. Please wipe your perspiration off the climber machine after each
use. Be careful not to get excessive moisture on the computer display panel as this might
cause an electrical hazard or electronics to fail.
Please keep the climber machine, especially the computer console out of direct sunlight to
prevent screen damage.
Please inspect all assembly bolts, nuts, screws, and pedals on the machine for proper
tightness every week.
Storage
Store the climber machine in a clean and dry environment away from children.

TROUBLESHOOTING

PROBLEM: The climber machine wobbles when in use.
SOLUTION: Turn the adjustable leveler on the front or rear stabilizer as needed to level the
climber machine.
PROBLEM: There is no display on the computer console.
SOLUTION: Remove the computer console and verify the wires that come from the
computer console are properly connected to the wires that come from the front post.
SOLUTION: Check if the batteries are correctly positioned and battery springs are in proper
contact with batteries.
SOLUTION: The batteries in the computer console may be dead. Replace with new
batteries.
PROBLEM: There is no heart rate reading or heart rate reading is erratic / inconsistent.
SOLUTION: Make sure that the wire connections for the hand pulse sensors are secure.
SOLUTION: To ensure the pulse readout is more precise, please always hold on to the
handlebar grip sensors with both hands instead of just with one hand when you try to test
your heart rate figures.
SOLUTION: Avoid gripping the hand pulse sensors too tight. Try to maintain moderate
pressure while holding onto the hand pulse sensors.
PROBLEM: The climber machine a squeaking noise when in use.
SOLUTION: The bolts may be loose on the climber machine. Please inspect all of the bolts
and tighten any loose bolts.
If the above troubleshooting section does not fix the problem, discontinue use the
climber machine.
PLEASE CONTACT YOUR LOCAL DEALER FOR
SUPPORT.
20

Advertisement

Table of Contents
loading

Table of Contents