Maintenance; Troubleshooting - Life Gear 20260 Classic II Owner's Manual

MAINTENANCE

Cleaning
The upright bike can be cleaned with a soft clean damp cloth. Do not use abrasives or
solvents on plastic parts. Please wipe your perspiration off the upright bike after each use.
Be careful not to get excessive moisture on the computer display panel as this might cause
an electrical hazard or electronics to fail.
Please keep the upright bike, especially the computer console out of direct sunlight to
prevent screen damage.
Please inspect all assembly bolts, nuts, screws, and pedals on the machine for proper
tightness every week.
Storage
Store the upright bike in a clean and dry environment away from children.

TROUBLESHOOTING

PROBLEM
The upright bike wobbles when in use.
There is no display on the computer
console.
There is no heart rate reading or heart rate
reading is erratic / inconsistent.
The upright bike makes a squeaking noise
when in use.
SOLUTION
Turn the rear stabilizer end cap on the rear
stabilizer as needed to level the upright bike.
1. Remove the computer console and verify
the wires that come from the computer
console are properly connected to the
wires that come from the handlebar post.
2. Check if the batteries are correctly
positioned and battery springs are in
proper contact with batteries.
3. The batteries in the computer console may
be dead. Replace with new batteries.
1. Make sure that the wire connections for
the hand pulse sensors are secure.
2. To ensure the pulse readout is more
precise, please always hold on to the
handlebar grip sensors with both hands
instead of just with one hand when you try
to test your heart rate figures.
3. Avoid gripping the hand pulse sensors too
tight. Try to maintain moderate pressure
while holding onto the hand pulse sensors.
The bolts may be loose on the upright bike.
Please inspect all of the bolts and tighten any
loose bolts.
13