Receiver Front Panel - Extron electronics FOX T USB User Manual

Receiver Front Panel

The receiver has the following indicator LEDs and connector:
A A A
Power LED
A
Config port
B
Host LED
C
Figure 6.
Power LED — This green LED lights to indicate that the unit is receiving power.
A
Config port — Connect a 9-pin D-to-2.5 mm TRS cable from a computer to
B
this 2.5 mm TRS jack for RS-232 communication (see
Communication
the computer for configuration and control of the transmitter via SIS commands (see
Remote Configuration and
NOTE: You can connect the computer to either the transmitter or the receiver.
Host LED — This green LED lights when both the transmitter and receiver are powered
C
and correctly connected by the appropriate fiber optic cable, and the receiver is
communicating with the host PC.
The LED blinks when the transmitter and receiver are both powered and connected, but
no USB devices are attached.
Hub LEDs — A green LED for each port lights when a peripheral device (such as a
D
keyboard or mouse) is connected to the associated USB port and is recognized by the
host PC.
Link LED — This green LED lights when the transmitter and receiver are successfully
E
connected together by the fiber optic cable and are receiving power.
E E
STATUS
LINK
CONFIG
HOST
B B C C
Hub LEDs
D
Link LED
E
Receiver Front Panel
on page 13). The Config port enables serial communication with
Control, beginning on page 16).
FOX T/R USB Extender Plus • Installation and Operation
D D
HUB
1 3
2 4
FOX R USB EXTENDER Plus
Connecting for Serial
10