Receiver Front Panel - Extron electronics DTP DVI 4K 230 D Series User Manual

NOTES:
•
•
B
DC power input connector — Plug the included external 12 VDC power supply into
either this 2-pole connector or the power input connector on the receiver (see
Supply Wiring

Receiver Front Panel

Figure 8 shows the front panel of the DTP DVI 4K 230 D receiver.
A
B
Figure 8.
A
DVI output connector — Connect a DVI display for the transmitted direct digital
image.
B
Audio output connector — Connect a stereo audio device to this 3.5 mm mini stereo
jack to receive the unbalanced audio output (see
connector).
C
RS-232 and IR (Control) pass-through connector — Connect a serial
communications port to this 3.5 mm, 5-pole captive screw connector for bidirectional
RS-232 communication and IR communication (see
Wiring
In order to fit in the junction box, the twisted pair cables and RJ-45 connectors
should not have a boot installed.
Do not use Extron STP201 or Skew-Free UTP series cable with these
products
on page 11 to wire the connector).
OUTPUTS
DVI-D
OVER DTP
RS-232
AUDIO
Tx Rx G Tx Rx
DTP DVI 4K 230 D Receiver Front Panel Connectors
on page 13 to wire the connector).
DTP DVI 4K 230 D Transmitter and Receiver • Installation and Operation
IR
C
figure 5 on page 7 to wire the audio
RS-232 and IR Connector
Power
9