Manual Mode; Switching The Test Voltage - AEMC 6470-b User Manual

All of the measurement functions described in § 5 (AUTO mode) can be performed
in MANUAL mode if necessary.
To access MANUAL mode:
• Press the Hz/OPTIONS button once. The Hz/OPTIONS symbol appears
• Use the ► button to switch from AUTO to MANUAL.
• When the tester is in MANUAL mode you can press Hz/OPTIONS repeat-
When a measurement is performed by a short or long press on the START/STOP
button (the circular arrows
stopped by a second press of this button.
Whenever a new measurement function is selected, the device automatically
changes back to AUTO mode.

6.1 Switching the Test Voltage

Available in all functions except mΩ.
If necessary, the test voltages can be switched to either 16 or 32V as follows:
• Press the Hz/OPTIONS button, then press it again to make the output volt-
• Use the ► button to switch to 16 or 32V, then press Hz/OPTIONS again.
This setting is retained when the unit is turned off.
Ground Resistance Tester Model 6470-B
uality Products Online at:
and the AUTO indicator blinks.
edly to see various parameters that can be set, depending on the measure-
ment function selected.
age (Uout) blink.
GlobalTestSupply
www.
CHAPTER 6

MANUAL MODE

on the display will rotate), the measurement can be
.com
sales@GlobalTestSupp
39