Resetting The Device (Device Reset) - Burkert 8681 Operating Instructions Manual

Control Head Type 8681
TechnicalData
6.8.

Resetting the device (Device Reset)

A restricted reset of the device to factory settings can be performed using the PC service program (see the "PC
service program" manual) or directly on the control head.
Procedure:
→
Simultaneously actuate T1 + T2 + T3 (approx. 2.5 s long) - to access "Device Reset" mode - the corresponding
blinking pattern is: always alternating 500 ms RED, 500 ms GREEN. If the device is not reset 10 s after switching
to "Device Reset" mode, this mode is automatically left.
→
Simultaneously actuate T1 + T2 + T3 again (approx. 2.5 s long) - this will reset the device. The blinking pattern
250 ms ON / 250 ms OFF in the fault color indicates that the device was reset.
Device Reset resets the following values to the factory settings:
• Teach positions S1...S3
• Feedback fields from S1...S3
• Resettable switching cycle counters V1...V3
• Resettable operating duration
• Service intervals switching cycles V1...V3
• Service interval operating duration
• Service/maintenance notification
(signaling of elapsed maintenance intervals)
• Manual control function
• External initiator S4 in = NO
• Feedback external initiator S4 as S1
Device Reset does not reset the following values:
• Switching cycle counter Total V1...V3
• Operating duration Total
• Position measuring system averaging system
• AS-i address
• AS-i profile
• DeviceNet Input Assembly
all positions "not taught"
(see Chapter "6.7.1" on page 25)
(see Chapter "6.7.2" on page 26)
(see Chapter "6.7.2" on page 26)
(see Chapter "6.7.2" on page 26)
(see Chapter "6.7.2" on page 26)
inactive (see Chapter "6.7.2" on page 26)
active (see Chapter "6.7.3" on page 26)
(see Chapter "17.1" on page 82)
not active (see "PC service program" manual)
(see PC service program)
(see chapter "11.8" on page 51)
(see Chapter "12.11.1" on page 60)
English
27