Setting The Color Combinations; Blinking Pattern & Fault Signaling - Burkert 8681 Operating Instructions Manual

17.1.

Setting the color combinations

Setting of the possible color combinations with the help of the DIP switches:
S1 S2
green yellow
yellow green
green red
red green
green yellow
yellow green
green red
red green
green yellow
yellow green
green red
red green
green yellow
yellow green
green red
red green
(S4IN may be normally open (NC) or normally closed (NO) - factory setting: Normally open contact (can be
changed via the PC service program - connect control head via service interface to the PC, note the "PC Service
Program" manual, note sub-menu "General start-up".)
17.2. Blinking pattern & fault signaling
The LEDs flash in different "blinking patterns" in the event of a fault or in various states:
Blinking patterns
82
S3 S4 Fault
green
yellow
green yellow
red yellow
yellow
green
red yellow
green yellow
green green
yellow yellow
green green yellow
red red yellow
yellow yellow
green green
red red yellow
green green yellow
ON OFF
100 ms 100 ms
English
Control Head Type 8681
LEDColorAssignments
DIP1 DIP2
red 0 0
red 1 0
0 1
1 1
red 0 0
red 1 0
0 1
1 1
red 0 0
red 1 0
0 1
1 1
red 0 0
red 1 0
0 1
1 1
Note
Flashes three times in the corresponding color for
that position:
Teach-In confirmation (after successful teaching:
the color for position 1 and 2 is continuously on)
Flashes three times in the corresponding fault color:
- if target could not be located in the measuring area
during teaching or
- if teach position is too close (±0.5 mm) to a previously
defined teach position or
- if magnetic manual control is used, even though manual
control function was disabled by software
DIP3 DIP4
0 0
0 0
0 0
0 0
1 0
1 0
1 0
1 0
0 1
0 1
0 1
0 1
1 1
1 1
1 1
1 1