Confirming Error Messages - Samson 3730-5 Mounting And Operating Instructions

Operation
Condensed state
Maintenance alarm
Function check
Maintenance required/
maintenance demand-
ed
Out of specification
If the positioner has not been initialized, the
maintenance alarm icon ( ) appears on the
display as the positioner cannot follow its set
point.
If fault alarms exist, the possible source of
error is displayed in Code 49 onwards. In
this case, Err appears on the display.
S
Refer to the code list (section 14) for possible
causes and the recommended action.
8.3.1 Confirming error mes-
sages
Enable configuration:
Note:

If no settings are entered within 120
seconds, the enabled configuration
function becomes invalid.
Turn g Code 3, display: No
Press , Code 3 blinks.
78
Positioner display
Text e.g. tESting, TunE
or tESt
blinking
Example:
Error caused by pin position
Turn  YES
Press , display:
Confirming error message:
Turn  Select the error code that you
want to confirm.
Press .
The error message is confirmed.
EB 8384-5 EN