Samson 3730-5 Mounting And Operating Instructions page 61

Malfunction/fault
Designation
Position
Parameters
Binary contact 1
AUtO Automatic
CL
Clockwise
CCL
Counterclockwise
Err Error
ESC
Cancel
LOW w too low
MAN Manual setting
MAX
Maximum range
No Not available/not active
NOM Rated travel
RES Reset
RUN
Start
SAFE Fail-safe position
SUb Substitute calibration
TunE
Initialization in progress
YES Available/active
ZP Zero calibration
tEStinG Test function active
Increasing/increasing

Increasing/decreasing

Fig. 23: Display
EB 8384-5 EN
Manual mode Closed-loop operation
Enable
Maintenance demanded
Configuration
Maintenance required
Blinking icon: out of specification
Operating controls and readings
mm
%
S
Fail-safe position active
blinking: positioner not initialized
S blinking: Valve in mechanical fail-safe position
(see SET_FAIL_SAFE_POS parameter in the
AO Transducer Block (AO TRD)
KH 8384-5
u
mm
%
S
and together: AO Transducer Block is in the
MAN mode u KH 8384-5
and S both blinking: The positioner is manual
mode while the mechanical fail-safe posi-
tion (SET_FAIL_SAFE_POS) has been de-
manded over the fieldbus. After exiting the
manual position, the valve moves to the
fail-safe position.
blinking: emergency mode (see error code 62 on
page 94)
Code
Bar graph for set point
deviation or lever posi-
tion
Units
Binary contact 2
61