Samson 3730-5 Mounting And Operating Instructions page 8

Firmware revisions (Communication K)
Further details can be found in u KH 8384-5. KH 8384-5 is included on the enclosed CD-ROM and
is available on our website.
BUS_ADDRESS parameter
Device type
Additional function blocks
New functions
Action on fault detection
Partial stroke test (PST)
Partial stroke test (PST)
Partial stroke test (PST)
8
K 1.24
The bus address has the default setting of 248.
In the delivered state, the device is configured as a basic device.
K 1.25
Internal revisions
K 2.01
• 2x DO (Discrete Output)
• 1x IS (Input Selector)
• 1x MAI (Multiple Analog Input)
• 1x MAO (Multiple Analog Output)
In the DO Function Block (Discrete Output), the following new functions
are implemented:
• Discrete analysis of on/off valves
• Start partial stroke test (PST)
• Start and reset the data logger
• Resetting the diagnosis
• Stop diagnosis
• Move to fail-safe position
• Lock on-site operation
If the AO Transducer Block is in O/S mode and the condensed state
changes to "Maintenance alarm", the following actions can be started:
• Hold last value
• Move valve to fail-safe position
• Move to a predefined fault state value
K 2.02
Configuration of the partial stroke test (PST) over the FF parameters is
no longer possible. Configuration over the TROVIS-VIEW software is
still possible.
K 2.03
Configuration of the partial stroke test (PST) over the FF parameters and
TROVIS-VIEW software is possible. The partial stroke test can be started
by the binary input BI2.
K 2.04
Internal revisions
K 2.05
Internal revisions
EB 8384-5 EN