Operation; Enabling And Selecting Parameters; Operating Modes; Automatic And Manual Modes - Samson 3730-5 Mounting And Operating Instructions

8 Operation

WARNING!
Risk of injury due to the actuator
stem extending or retracting.
Do not touch or block the actuator
stem.
8.1 Enabling and selecting pa-
rameters
All codes and their meaning and default set-
tings are listed in the code list in section 14.
Codes which are marked with an asterisk
must be enabled with Code 3 before the as-
sociated parameters can be configured as
described below.
Turn g Code 3, display: No
, Code 3 blinks.
Press
Change the setting in Code 3.
 YES
Turn
Press , display:
Configuration is enabled.
You can now configure codes one after the
other:
EB 8384-5 EN
Code 3
Configuration not enabled
Configuration enabled
Turn to select the required code.
Press to activate the selected code. The
code number starts to blink.
Turn to select the setting.
Press to confirm the selected setting.
Note:

If no settings are entered within
120 seconds, the enabled configura-
tion function becomes invalid and the
display returns to Code 0.
Cancel the setting:
To cancel a value before it is confirmed (by
pressing ) proceed as follows:
g ESC
Turn
Press .
The entered value is not adopted.

8.2 Operating modes

8.2.1 Automatic and manual
modes
After initialization has been completed suc-
cessfully, the positioner is in
mode (AUTO).
Operation
Canceling the reading
automatic
75