Table of Contents
Advertisement
The components
▀
The shunt valve
The shunt valve controls the heat supply from the boiler to the radiator circuit. Effecta Complete
is fitted with motorised shunt control. The room temperature can be adjusted on a scale on the
thermostat. An automatic system will significantly reduce fuel consumption and provide a more
comfortable environment.
The valve combination
The mixing valve is used to ensure that the temperature of the hot water in your shower and
elsewhere in the house is comfortable. Set the system to the temperature you want by turning
the thermostat between +/-.
The burner
The burner is mounted on the left or right side. The burner heats the water in the boiler which
provides heat to the domestic and hot water.
The turbulators
In the tubes in the convective part hangs the turbulators. The turbulator`s function is to reduce
the heat in the flue gases on behalf of the temperature in the boiler. They must always be fitted
in the boiler. If the flue gas temperature should be to low, the turbulators can be cut off. Always
contact the installer before doing this.
The sealings
The seals on the hatches must be checked every year. If the hatches do not seal properly, the
efficiency and the combustion process of the boiler will deteriorate.
▀
Exploded view, burner
1.
Combustion fan
2.
Fan seal
3.
Electrical console
4.
Flame detector
5.
Rear housing
6.
Rear housing seal
7.
Cover overheating protection
8.
Ignition console
Effecta AB Västra Rågdalsvägen 21 434 99 Kungsbacka Sweden +46-300 - 22320 info@effecta.se
9.
Feeding tube
10.
Overheating protection
11.
Seal feeding tube
12.
Pellet retarder
13.
Inner tube
14.
Outer tube
15.
Stop plate
7
Advertisement
Table of Contents
