Table of Contents
Advertisement
3. Locate the Gigabit network board port 3, 4, 5 into the main board, tighten
the screws, as shown in Figure 3.
4. Close and install the processor again, see ―Assemble the VSP 9516S‖ in
Part 3.
Part 3: Assemble the VSP 9516S
Specific steps are as follows:
1. Secure the back panel with the screws.
2. Replace the top cover on the VSP 9516S.
3. Fasten it with the screw that were removed in ―Take Apart the VSP 9516S‖
part.
4. If need, reconnect all cables.
VSP 9516S
(Figure 3)
User Manual
131
Advertisement
Table of Contents
