RGBlink VSP 9516S User Manual page 105

6. System Setup and Operation
How to Realize LED Display Connection
e. Turn the knob, and choose <D PORT Offset (A/B) Y>, and set D PORT Offset (A/B) Y
as 240 (Note: D PORT Offset (A/B) Y=HORIZONTAL CARD×HEIGHT, before we set
horizontal card as 2 and height as 120). Shown as follows:
f. Turn the knob, choose <DISPLAY CONNECTION>, push the knob to confirm, turn the
knob again, and choose <CONNECTION MODE>. the OLED module show as follows:
Choose the connection mode, the setting is same as Port U1. Then connection of both the
Port D and Port U of One Sending Card to LED Display is finished.
Rendering is as follows:
VSP 9516S
>
CHOOSE CABLE
HORIZONTAL CARD
VERTICAL CARD
WIDTH
>
HEIGHT
D PORT Offset (A/B) X
D PORT Offset (A/B) Y
DISPLAY CONNECTION
HEIGHT
D PORT Offset (A/B) X
D PORT Offset (A/B) Y
>
DISPLAY CONNECTION
>
CONNECTION MODE
SEND TO RECEIVER
User Manual
PORT D
2
3
120
120
0
240
>>
120
0
240
>>
105