Table of Contents
Advertisement
6. System Setup and Operation
How to Realize LED Display Connection
The setting is as follows:
(8) After setting, turn the knob, choose <DISPLAY CONNECTION>, push the knob to
confirm, turn the knob again, and choose <CONNECTION MODE>. VSP 9516S
supports 8 kinds of connection modes, they are
and
, user can choose the mode according to actual connection mode.
Send to receiver after choose the connection mode, observe the LED display and make
sure if display image is correct. If wrong, change the connection modes. Then connect the
Port D or Port U of One Sending Card to LED display is finished.
VSP 9516S
>
HEIGHT
D PORT Offset (A/B) X
D PORT Offset (A/B) Y
DISPLAY CONNECTION
HEIGHT
D PORT Offset (A/B) X
D PORT Offset (A/B) Y
>
DISPLAY CONNECTION
>
CONNECTION MODE
SEND TO RECEIVER
User Manual
120
0
0
>>
,
,
,
,
120
0
0
>>
,
,
102
Advertisement
Table of Contents
