Table of Contents
Advertisement
6. System Setup and Operation
How to Realize LED Display Connection
3. Connect the Port D and Port U of Two Sending Cards to LED Display
(1) First, make sure the device is in normal operation. The red power indicator lights when
device has power supply and the green signal indicator lights when device has signal
input.
(2) Choose the input signal, for example, choose DVI.
(3) Connect four cables to Port U1, Port D1, Port U2 and Port D2 respectively.
(4) Connect Port D1 and Port U1 of No.1 Sending Card to LED display, the settings are
same as ―Connect the Port D and Port U of One Sending Card to LED Display‖.
(5) Same as above, connect Port D2 and Port U2 of No.2 Sending Card to LED display.
(6) Turn the knob, choose <DISPLAY CONNECTION>, push the knob to confirm, turn the
knob again, choose <SENDING CARD NO.>, push the knob to confirm, turn the knob,
choose NO.2, push the knob to confirm.
(7) Turn the knob, choose <QUICK CONNECTION>, push the knob to confirm. Turn the
knob, choose <RECEIVING CARD SET>, push the knob to confirm, and enter to the
to the next level menu, the OLED module show as follows:
VSP 9516S
SENDING CARD TYPE
>
SENDING CARD NO.
BRIGHTNESS
QUICK CONNECTION
SENDING CARD TYPE
SENDING CARD NO.
BRIGHTNESS
>
QUICK CONNECTION
User Manual
LINSN
NO.2
50%
>>
LINSN
NO.2
50%
>>
106
Advertisement
Table of Contents
