RGBlink VSP 310 Quick Start

VSP 310 – Quick Start
For full installation, configuration, and operation details, refer to the
NOTE
VSP310 user manual, which is available at www.rgblink.com.
This guide provides quick start instructions for an experienced installer to set up
and operate the VSP 310.
Installation and cabling features
Rear Panel
Interface
1
Mini switches
2 8 9 13 14
RJ-45 port
3
11 16
USB control connecor
4
RS232 control connector
DVI+VGA input connector
5
Step 1-Mounting
Turn off or disconnect all equipment power sources.
Step 2-DVI input
DVI can be input from the computer or laptop
and other DVI source; users can use DVI to DVI
cable Or DVI to DVI+ VGA adapter to receive
both DVI and VGA signals.
DVI to DVI+VGA cable is
one end in DVI-I or DVI-D
male connector, another
end in DVI-I or DVI-D
female connector with a
VGA male connector.
DVI to VGA adapter, one end in DVI-I
connector and another end in VGA male.
Step 3-VGA input
As the connector is DVI input, VGA input is working by DVI to
DVI + VGA cable or DVI to VGA connector.
Currently VGA input support two resolution as following：
1024×768×60Hz, 1280×1024×60Hz.
Step 4-DVI Output
Input the signal from computer, DVI signal
generator and so on.
DVI1 OUT and DVI2 OUT output interface of these two images in
the divider mode, the output DVI or VGA input with resolution of
the same; in split-screen mode, respectively, DVI or VGA input,
1 / 2 (with horizontal or vertical one point two one point two of the
split screen function), the resolution always remain with DVI or
VGA input resolution unanimously.
Address:S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197
Email: rgblinkcs@gmail.com
VIEWSIZE THE WORLD
6
10 15
12
18
19
DVI to DVI+VGA
cable
Fax:00865925771202
http://www.rgblink.com
7
DVI output connector
Power connector
17
Sending cardDVI input port
Power on/off
Power port IEC-3
NOTE
LED display sending cards. In step 4, if you need to
install four sending cards, the other two must be
installed in TSH4 (4 sending cards holding frame). Or
DVI to VGA
use a DVI split cable, or use DVI splitter, as follows.
adapter
DVI splitter, used to distribute
D V I w i t h 1 i n 2 o u t . A l l
connectors are in female ones,
u s e c o m m o n D V I c a b l e t o
connect between VSP 310 and
DVI splitter.
VSP 310 can support to install two full-color
DVI split cable is one end in
m a l e , a n o t h e r t w o e n d s i n
female. M a l e o n e i s u s e d t o
c o n n e c t w i t h VSP 310 DVI
output, female ones are used to
connect directly to the sending
cards.
VSP 310 Quick Start
Rev 1.0
Page 1 of 3