Displaying The Measured Values Via Wago-I/O-Check; Figure 23: Measured Values, Overview - WAGO SYSTEM 750 User Manual

70 Commissioning
Pos : 92 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/__ noc h nic ht ei ns ortierte Ü berschriften müss en noc h eins orti ert werden __/Anzeigen der Mes s werte mit WAGO-I/O-CHEC K - Ü berschrift 2 @ 13\mod_1355494395030_21.doc x @ 107680 @ 2 @ 1
8.2 Displaying the Measured Values via WAGO-I/O-
CHECK
Pos : 93 /Serie 750 ( WAGO-I/O-SYST EM)/In Betrieb nehmen/Anzeig en der Mess wer te mi t WAGO-I/O-CH ECK 750-0493 @ 16\mod_1372771300798_21.doc x @ 125355 @ @ 1
The measured values are displayed in the "3-phase power measurement" dialog in
several views.
The Overview view displays the measured values of all three phases
continuously. These are:
• Current, voltage Lx-N, active power, cos phi and frequency.
An undervoltage is identified as a red square.
Change of the Measuring Units!
Specify the prefixes of the measuring units by selecting Home > Settings >
Application. See section "Configuration with WAGO-I/O-CHECK" >
"Application" Tab.
The units can only be changed in the lists with the same physical variables. For
lists with different variables, base units are always used!

Figure 23: Measured Values, Overview

WAGO-I/O-SYSTEM 750
750-493 3-Phase Power Measurement Module
Manual
Version 1.2.0