Figure 17: "Settings" Dialog - WAGO SYSTEM 750 User Manual

60 Commissioning

Figure 17: "Settings" Dialog

The main menu (1) with the Application, Phase L1, Phase L2, Phase L3, I/O
Module, Energy and Factory Settings tabs are on the left side. These are explained
in more detail in the following sections.
At the window's bottom you can find the command bar (2) with 4 buttons.
Use [Import] to load the settings from your hard drive that you may have already
saved when setting up another I/O module. You can change these settings if
necessary and then [Save] them to the I/O module.
Use [Export] to save the current settings to your computer to simplify future
configurations.
Pay attention to energy values!
The energy values are not taken into account when importing and exporting!
[Save] writes any changed settings to registers, i.e. the configuration of the I/O
module and the application settings are changed. The "Settings" dialog closes.
To not save and discard the changed settings, click [Close]. The "Settings" dialog
closes.
WAGO-I/O-SYSTEM 750
750-493 3-Phase Power Measurement Module
Manual
Version 1.2.0