WAGO-I/O-SYSTEM 750
750-493 3-Phase Power Measurement Module
Figure 16: "3-Phase Power Measurement" Dialog
The following buttons appear in the Home (1) ribbon:
[Disconnect]
[Snapshot]
[Settings]
[Calibration]
The buttons for the individual measured value views appear in the menu (2).
The status bar (3) displays the connection icon and IP address of the fieldbus
coupler/controller or the name of the COM port.
Click [Settings] to open the "Settings" dialog in which you can configure the
application and I/O module.
Manual
Version 1.2.0
Separates the fieldbus coupler/controller from the PC
Opens a "Save as" dialog to save all current measured
values and I/O module settings as a CSV file. In this
dialog, enter a file name and select a location to save the
file, e.g. see section "Appendix".
Opens the settings dialog.
Opens the calibration dialog. More information is
available from the WAGO Support.
Commissioning
59