Activation Of The System - Ducati Streetfighter Owner's Manual

Activation of the system

To activate the system, the motorcycle must be stationary
and safely parked.
To enable Traction Control, enter the menu and set "DTC" to
"On" by pressing RESET switch (14, fig. 5) for 3 seconds;
after 3 seconds the message "DTC" is activated, which
indicates the inclusion of the DTC. The message "DTC",
when active, is visible not only in normal view, but also within
the pages of the menu.
Note
The functions of the system
To operate the system, the motorcycle must be stationary
and safely parked.
Each time DTC is activated, the Traction Control ECU will set
the sensitivity level to 8; the level may then be adjusted using
the function "Traction Control Sensitivity Level Setting (DTC
SETUP)".
To disable Traction Control, enter the menu and set "DTC"
to "OFF" by pressing again RESET switch (14, fig. 5) for 3
seconds; once the 3 seconds have elapsed, the message
"DTC" will disappear from the display, thereby indicating
deactivation of the Ducati Traction Control system.
If the engine suddenly stops or is switched off (Key-Off)
while
Traction Control is activated, the function will NOT be
disabled but will still be active (DTC On) at the next Key-ON.
If, however, battery power is suddenly cut off (Batt-OFF),
when battery power is restored and upon next Key-On, the
Traction Control will no longer be activated (DTC OFF).
Routine maintenance
To ensure that system continues to function correctly it is
necessary to observe the manufacturer's routine
maintenance schedule
E
35