Ducati Streetfighter Owner's Manual page 18

Upon Key-On, the dashboard always displays the following
information (and any functions activated previously are
deactivated, apart from the Traction Control, when active):
ODOMETER
SPEED
RPM BARGRAPH
ENGINE COOLANT TEMPERATURE BARGRAPH
With the button (1, fig. 10) "▲", the ODOMETER READOUT
(TOT) will cycle through the following functions:
TRIP
TRIP FUEL (only if active)
CLOCK
T_AIR
DTC (available only if Traction Control is present and active)
to go back to the Odometer function (TOT).
Pressing button (2, fig. 10) "▼" gives access to the MENU
and the following functions are displayed one after another:
ERROR (only if at least one error is present)
BATT
RPM
LIGHT SET
LAP (OFF or ON)
LAP MEM
DDA (OFF or ON)
ERASE DDA
DTC OFF/ON (active only if Traction Control is fitted)
DTC SETUP (active only if DTC has been activated)
DQS OFF/ON (it works only if the vehicle is equipped with
the electronic gearbox kit, Performance code 96524412A)
TIME SET
1
2
CODE (only if active)
Warning
To fit the electronic gearbox kit, Performance code
96524412A, contact a Ducati Dealer or Authorised Service
Centre
Important
This menu is active only if the speed of the motorcycle
is less than 20 km/h. If this menu is open and the speed of
the motorcycle exceeds 20 km/h, the dashboard
automatically exits the menu and returns to the initial display.
It is possible to exit the MENU at any time, however, by
pressing switch (2, fig. 10) "▼" for 3 seconds.
E
fig. 10
17