Configuring The Profiler; Viewing And Creating A; Profile - Brainchild P41 User Manual

4-9 Configuring the profiler

4-9 Configuring the profiler
when first installing a profiler you should check that the configuration
conforms to your requirement.
The following parameters are common to all profiles:
Global Data Global Data
STAR : set point value at start of profile
END : set point value at end of profile
DLAY : Delay time before profile start
PFR
HBT
The following parameters are used for a specific profile:
Profile Data Profile Data
PROF : Profile number selected for view
HBBD : Holdback band
STSP : Start set point value
RMPU : Unit for ramp segment
DLLU : Unit for dwell segment
The following parameters which apply to each segment in a specific

profile:

Segment Data Segment Data
SGNO : Segment number
SGTY : Segment type
TGSP : Target set point
RTRR : Ramp time or ramp rate
P2EV : PID selection and event output states
HBTY : Holdback type
DLLT : Dwell time
SEG : Target segment number for jump segment
CYCL : Repeat number of cycle
FSP : Final set point for the end segment
4-10 Viewing and creating a profile 4-10 Viewing and creating a profile
Refer to section 1-5 section 1-5
configuration page. After completing the configuration of all the parameters
including those parameters which are common to all profiles, you can
proceed to the profile page to create a profile. To create a specific profile
you need to set the profile number at first, then set HBBD, STSP , RMPU,
DLLU and SGNO for this profile.
: Power fail recovery
: Holdback wait time
for key operation. Press page key to obtain
UM0P411A
73