Event Outputs And Pid Selection - Brainchild P41 User Manual

4-11 Event Outputs and PID Selection

4-11 Event Outputs and PID Selection
The event outputs and PID selection are defined by parameter P2EV in
the segment data and parameters OUT2, OUT3 and OUT4. There are
up to 3 event outputs can be configured. The register 95 shown in
section 1-6 describes how to define event status and select PID values.
There are two sets of PID parameters stored in the memory. If the unit is
in RUN or HOLD mode, the PID sets are selected by the most significant
bit of parameter P2EV. If the unit is in STAT mode (static or controller
mode), the PID sets are selected by event input function EIFN. If the
unit is in A-T mode, then PB1, TI1, TD1 are selected. If the unit is in AT2
mode, then PB2, TI2 and TD2 are selected.
77
UM0P411A