Programming Port - Brainchild P41 User Manual

1-3 Programming Port

1-3 Programming Port
Rear
Terminal
A special connector can be used to touch the programming port
which is connected to a PC for automatic configuration, also can be
connected to an ATE system for automatic calibration and testing.
The programming port is used for off-line automatic setup and testing
procedures only. Don't attempt to make any connection to these pins
when the unit is used for a normal control purpose.
$ "
# !
6 4 2
5
3 1
UM0P411A
Front
Panel
Figure 1.2 Figure 1.2
Programming Port Programming Port
Overview Overview
Access Hole Access Hole
11