Retransmission - Brainchild P41 User Manual

Setup
Enters the configuration page. Enters the configuration page.
Select COMM for OUT4 or OUT5 . Set unequal addresses for those units Select COMM for OUT4 or OUT5 . Set unequal addresses for those units
which are connected to the same port. which are connected to the same port.
Set the Baud Rate ( Set the Baud Rate (
are conform to PC setup conditions. are conform to PC setup conditions.
If you use a conventional 9-pin RS-232 cable instead of CC94-1, the cable If you use a conventional 9-pin RS-232 cable instead of CC94-1, the cable
should be modified for proper operation of RS-232 communication should be modified for proper operation of RS-232 communication
according to according to Section 2-10.

3 - 14 Retransmission

3 - 14 Retransmission
The profiler can output (retransmit) process value or set point value
via its retransmission terminals RE+ and RE- provided that the
retransmission option is ordered. To accomplish this you can select
(REPV) or
parameters should be configured for retransmission:
OP4L : Low limit value for output 4
OP4H : High limit value for output 4
REL4 : Retransmission low scale value for output 4
REH4 : Retransmission high scale value for output 4
OP5L : Low limit value for output 5
OP5H : High limit value for output 5
REL5 : Retransmission low scale value for output 5
REH5 : Retransmission high scale value for output 5
Example: If you want to output 4 mA for PV at 0 C and 20mA for PV at
1000 C via output 5, then you should set the following
parameters:
OUT5 =
OP5L = 20.0 (%), since 20% of a 0-20mA output module
OP5H = 100.0 (%)
REL5 = 0 C
REH5 = 1000 C
BAUD BAUD ), and Parity Bit ( ), and Parity Bit (
(RESP) for OUT4 or OUT5. The following
L
equipped will output 4 mA ( 20% of 20mA span ).
L
L
PARI PARI ) such that these values ) such that these values
UM0P411A
L
63