Chapter 2 Installation; Unpacking; Mounting - Brainchild P41 User Manual

Chapter 2 Installation

Chapter 2 Installation
Dangerous voltages capable of causing death are sometimes Dangerous voltages capable of causing death are sometimes
present in this instrument. Before installation or beginning any present in this instrument. Before installation or beginning any
cleaning or troubleshooting procedures the power to all equipment cleaning or troubleshooting procedures the power to all equipment
must be switched off and isolated. Units suspected of being faulty must be switched off and isolated. Units suspected of being faulty
must be disconnected and removed to a properly equipped must be disconnected and removed to a properly equipped
workshop for testing and repair. Component replacement and workshop for testing and repair. Component replacement and
internal adjustments must be made by a qualified maintenance internal adjustments must be made by a qualified maintenance
person only. person only.
This instrument is protected throughout by This instrument is protected throughout by
To minimize the possibility of fire or shock hazards, do not expose To minimize the possibility of fire or shock hazards, do not expose
this instrument to rain or excessive moisture. this instrument to rain or excessive moisture.
Do not use this instrument in areas under hazardous Do not use this instrument in areas under hazardous
conditions such as excessive shock, vibration, dirt, moisture, conditions such as excessive shock, vibration, dirt, moisture,
corrosive gases or oil. The ambient temperature of the areas should corrosive gases or oil. The ambient temperature of the areas should
not exceed the maximum rating specified in Chapter 6. not exceed the maximum rating specified in Chapter 6.
Remove stains from this instrument using a soft, dry cloth. Remove stains from this instrument using a soft, dry cloth.
Don't use harsh chemicals, volatile solvent such as thinner or strong Don't use harsh chemicals, volatile solvent such as thinner or strong
detergents to clean the instrument in order to avoid deformation or detergents to clean the instrument in order to avoid deformation or
discoloration. discoloration.

2-1 Unpacking

2-1 Unpacking
Upon receipt of the shipment remove the unit from the carton and Upon receipt of the shipment remove the unit from the carton and
inspect the unit for shipping damage. inspect the unit for shipping damage.
If any damage due to transit , report and claim with the carrier. If any damage due to transit , report and claim with the carrier.
Write down the model number, serial number, and date code for Write down the model number, serial number, and date code for
future reference when corresponding with our service center. The future reference when corresponding with our service center. The
serial number (S/N) and date code (D/C) are labeled on the box and serial number (S/N) and date code (D/C) are labeled on the box and
the housing of control. the housing of control.

2-2 Mounting

2-2 Mounting
Make panel cutout to dimension shown in Figure 2.1. Make panel cutout to dimension shown in Figure 2.1.
Take both mounting clamps away and insert the controller into Take both mounting clamps away and insert the controller into
panel cutout. Install the mounting clamps back. Gently tighten panel cutout. Install the mounting clamps back. Gently tighten
the screws in the clamp till the controller front panels is fitted the screws in the clamp till the controller front panels is fitted
snugly in the cutout. snugly in the cutout.
32
UM0P411A
Double Insulation Double Insulation -- . -- .