Table of Contents
Advertisement
Chapter 2 Installation
Dangerous voltages capable of causing death are
sometimes present in this instrument. Before installation or
beginning any troubleshooting procedures the power to all
equipment must be switched off and isolated. Units suspected
of being faulty must be disconnected and removed to a
properly equipped workshop for testing and repair.
Component replacement and internal adjustments must be
made by a qualified maintenance person only.
To minimize the possibility of fire or shock hazards, do not
expose this instrument to rain or excessive moisture.
Do not use this instrument in areas under hazardous
conditions such as excessive shock, vibration, dirt, moisture,
corrosive gases or oil. The ambient temperature of the areas
should not exceed the maximum rating specified in Chapter 6.
2 - 1 Unpacking
Upon receipt of the shipment remove the unit from the carton
and inspect the unit for shipping damage.
If any damage due to transit , report and claim with the carrier.
Write down the model number, serial number, and date code
for future reference when corresponding with our service
center. The serial number (S/N) and date code (D/C) are
labeled on the box and the housing of the unit.
2 - 2 Mounting
Make panel cutout to dimension shown in Figure 2-1.
22
UM0L911C
Advertisement
Table of Contents
