Kyocera FS-6950DN Service Manual page 87

19. Remove the one connector.
20. Remove the two screws (A) and then
remove the HV plate.
21. Remove the two screws (B) and then
remove the engine R ground plate, engine L
ground plate and shield plate.
22. Check or replace the engine PWB and refit
all the removed parts.
To replace the engine PWB, remove the
EEPROM from the old engine PWB and
mount it to the new engine PWB.
HV plate
Connector
Screw (A)
EEPROM
Screw (B)
Engine R
grounding plate
Screw (B)
Screw (A)
Engine L
grounding plate
Shield plate
Figure 1-5-35
2F7-2
Engine PWB
1-5-25