Kyocera FS-6950DN Service Manual page 76

2F7
6. Release the six latches and then remove the
separation charger brush unit.
7. Check or replace the transfer roller and sep-
aration charger brush unit and refit all the
removed parts.
CAUTION: Note the following, when refitting
the separation charger brush unit.
A. The separation charger brush unit is
inserted into the four projections of the
frame and does not run on to the projec-
tions.
B. The separation charger brush unit is
firmly in contact with the separation charger
plate of the frame.
1-5-14
Pro-
Latch jection
A
Separation charger
brush unit
Viewpoint
B
Separation
charger plate
Viewpoint
Separation charger
brush unit
Viewpoint
Pro-
jection
Pro-
jection
Separation
charger plate
Projection
Separation
charger brush
Separation
charger brush unit
Figure 1-5-19
Pro-
jection
Frame