Kyocera FS-6950DN Service Manual page 44

2F7-3
Service items
>>Paper Feed
>>Maintenance
1-3-14
Setting the paper feed operation (printer driver priority mode)
Description
With printer driver priority mode, when selecting the specific paper feed location (a paper
cassette or MP tray) with the printer driver (it is not automatic selection), paper is fed from
the selected location. Message "Add Paper" is displayed when there is no paper in that loca-
tion. When selecting the MP tray as the paper feed location, paper is fed with the timing of
maximum size (Ledger). As for the setting media type (setting the paper type), setting of the
printer driver is notified to the engine PWB. Duplex printing operation is still the ordinary
operation, and paper jam occurs if paper size is different from the setting of the printer.
Purpose
To set the printer driver priority mode which priority is given to the setup of a printer driver
when the ordinary paper feed operation mode is not suitable for the usage condition of the
user.
Method
1. Enter the service mode [>>Paper feed].
2. Press the OK key. Message [Paper feed?] will be displayed.
3. Select the mode (Special? or Normal?) pressing the
Special Ordinary paper feed operation mode
Normal Printer driver priority mode (Default)
4. Press the OK key.
Completion
Counter reset for the maintenance kit
Description
The "Install MK" message means that maintenance kit should be replaced at 300,000 pages
of printing. The interval counter must be manually reset using this service item. Maintenance
kit MK-430 includes the following units:
Drum unit
Developer unit
Fuser unit
Transfer roller
Separation charger brush unit
Paper feed system rollers
Purpose
To reset the life counter for the developer unit and drum unit included in maintenance kit.
Procedure for replacing the maintenance kit
Drum unit (See page P.1-5-11)
Developer unit (See page P.1-5-10)
Fuser unit (See page P.1-5-15)
Transfer roller (See page P.1-5-13)
Separation charger brush unit (See page P.1-5-13)
Paper feed system rollers:
Paper feed assembly [paper feed roller and pickup roller] (See page P.1-5-4)
Retard roller (See page P.1-5-5)
MP tray paper feed roller (See page P.1-5-8)
Procedure
1. Enter the service mode [>>Maintenance].
2. Press the OK key. [>>Maintenance?] will be displayed.
3. Press the OK key twice. The counter for each component is reset immediately.
Completion
Note:
Occurrences of resetting the maintenance kits are recorded on the service status page in
number of pages at which the maintenance kit was replaced (See page P.1-3-2).
This may be used to determine the possibility that the counter was errorneously or uninten-
tionally reset.
Description
key or key.