Kyocera FS-6950DN Service Manual page 84

2F7
1-5-8 PWBs
(1) Detaching and refitting the engine PWB
Procedure
1. Remove the fuser unit (See page P.1-5-10).
2. Remove the top cover (See page P.1-5-2).
3. Remove the left cover (See page P.1-5-3).
4. Remove the PSU fan motor (See page P.1-
5-28).
5. Stand the printer front side up.
6. Remove the five screws and then remove
the bottom plate 1.
7. Remove the four screws and then remove
the bottom plate 2.
8. Remove the two wires from the hooks and
notches.
9. Open the DU guide (duplex cover).
1-5-22
Bottom plate 1
Screw
Figure 1-5-30
DU guide (duplex cover)
Hook
Figure 1-5-31
Screw
Screw
Screw
Screw
Screw
Bottom plate 2
Screw
Screw
Notch
Wire
Screw