Kyocera FS-6950DN Service Manual page 26

2F7-2
Connecting the printer cables.
1. Connect the printer cable (parallel, USB or
network*) to the printer and the PC.
*: Remove the cap.
Connecting the power cord and toner installing.
1. Connect the power cord to the printer's AC
inlet and the other end into a power outlet.
2. Turn the power switch to on ( | ).
The printer will begin replenishing the toner;
this will take approximately 20 minutes.
3. Wait until the message display indicates [>
MSG language]. The default message lan-
guage is English.
4. Press or key repeatedly until the mes-
sage display shows the desired language
and then press OK key.
If you do not wish to change the setting,
press Cancel key.
5. The display returns to Ready.
1-2-8
s
Power switch
USB
Network
Parallel
Parallel cable
Figure 1-2-12
AC inlet
Power cord
Figure 1-2-13
USB cable
Cap
Network cable
> MSG language
? English