Charging And Using The Battery - Siemens HiPath 3000 Operating Instruction

Charging and using the battery

To charge the battery, insert the handset into the charging shell with the
keypad facing forwards.
Important:
Only place the handset in the designated charger. (For order
numbers see  page 167).
The charging status is indicated by the charge status LED.
{ lighting white: charged over 66%
{ lighting white: charged between 34 % and 66 %
y lighting white: charged between 11% and 33%
y lighting red: charged below 11%
y flashing red: battery almost empty (less than 10 minutes talktime)
xy xy x{ x{
• Initial charging: Charge the battery for at least 10 hours without
a break, regardless of the charging status icon.
• For future charging: you can replace your handset in the
charging shell each time it has been used. Charging is
electronically controlled which ensures that the battery is
charged optimally.
• The capacity of the Ex battery pack can diminish due to ageing
to the extent that it is no longer sufficient (increasingly faster
discharge) for the intended operating life. The Ex battery pack
must then be replaced by appropriately trained service
personnel.
Putting the handset into service
lighting white: battery being charged
19