Tools You Need; Step 1: Attaching The Wheels And Casters - Paxar Mobile Printing Station Monarch 9476 Assembly And Setup Instructions

Tools You Need--------------------------------------------------------------------------------------------

To assemble the Station, you need:

Step 1: Attaching the Wheels and Casters --------------------------------------------

1. Remove the following items from their packaging:
w To avoid hitting your fingers, use needle-nose pliers to hold
the end cap as you are hammering it onto the axle.
2. You may need an assistant for this step. Remove the
Make sure the printer power packs attached to the top of the
c
Station are not crushed during the next three steps.
flathead (common) screwdriver
Phillips screwdriver
wrenches: 7/16", 11/32", 1/4" and adjustable
rubber mallet
slip-joint pliers
needle-nose pliers
hammer
(2) 8" wheels
(2) 4" casters with brakes
(2) axle mounts
(2) axle end caps
(2) large washers
(1) axle
collapsed Station assembly from the carton. Hold the top
piece of packaging against the top of the Station and turn
the Station upside down on a firm surface. The top
packaging serves as a pad to protect the printer power
packs, which are attached to the top of the Station.
Chapter 1. Assembling the Station
1-3