Table of Contents
Advertisement
7. Position the charger between the retainer rods so the back
of the charger rests against the metal L-bracket. The
status lights on the front of the charger should face out.
(Figure 15.)
8. Place the rubber bracket across the top of the charger.
Use 1/4"-20 wing nuts, washers, and lockwashers to
attach the retainer rods to the rubber bracket as shown.
Tighten both wing nuts equally to secure the charger.
(Figure 15.)
Rubber
Bracket
Retainer
Rod
9. Plug the charger's power cord into the power outlet on the
inside wall of the cabinet.
Chapter 1. Assembling the Station
Figure 15
External Power
Socket
1-21
Advertisement
Table of Contents
