Table of Contents
Advertisement
Chapter 3.
The Station's battery charger is a fully automatic,
maintenance-free charger. You must charge the battery before
using the printers on the Station.
To charge the battery, plug the Station's AC power cord into a
grounded outlet. The status light on the front of the Station
indicates that the station is receiving power. (Figure 39.)
Charge the Station's battery:
When the Station is not in use, always leave the battery
n
charger plugged in and charging. The battery charger is
"intelligent;" it monitors the battery condition and does not
overcharge the battery.
Charging the Battery
Status
Light
before using the Station for the first time (charge it for
6 hours)
when a printer's LED indicates a "low battery" condition
(see "Battery Life" for indications of low battery
conditions)
when the Station is not in use.
Figure 39
3-1
Advertisement
Table of Contents
