Table of Contents
Advertisement
9476 Assembly and Setup Instructions
9. Slide the metal rod through the slot in the side of the drop
10. Slide a plastic washer onto the exposed end of the metal
11. You might need another person's help with this step. Hold
12. To collapse the shelf, lift the shelf from the sides and allow
1-12
shelf and into the hole in the Station's corner support.
Push the rod until it exits through the hole in the other
corner support. You may have to reach under the support
brace to guide the rod into the opposite hole. (Figure 7.)
rod. (Figure 7.)
the head or side of a hammer firmly against the end of the
rod with the end cap. While maintaining pressure, use a
second hammer to hammer an end cap onto the exposed
end of the rod. The end cap should lock firmly. (Figure 7.)
it to swing down. (Figure 8.)
To extend the shelf, lift the shelf until the rear lip slides
down onto the top of the support brace and locks in place.
Figure 8
Advertisement
Table of Contents
