Table of Contents
Advertisement
9476 Assembly and Setup Instructions
2. Center a strip of supply over the supply deflector. The
3. Lift one end of the supply deflector to remove it from the
4. Roll the O-rings out of their tracks and into the new
5. Replace the supply deflector in the supply well.
2-4
supply deflector's rubber O-rings must be positioned
inside the edges of the supply. (Figure 25.) If you do not
need to adjust the position of the O-rings, skip to step 6.
supply well. You may have to gently spread the supply
holders apart to release the supply deflector. (Figure 25.)
Supply
Deflector
O-Ring
positions.
(Figure 25.)
Figure 25
Advertisement
Table of Contents
