Paxar Mobile Printing Station Monarch 9476 Assembly And Setup Instructions page 22

9476 Assembly and Setup Instructions
3. Place the battery on the cabinet floor. Remove the
4. Slide the battery to the back of the cabinet.
5. Use a 15mm bolt, washer, lockwasher, and M5 nut to
6. Position the battery between the retainer rods. The writing
1-16
cardboard packaging. Use a 15mm bolt, washer,
lockwasher, and M5 nut to attach the white battery wire to
the positive (+) battery post. (Figure 11.)
Negative (-)
Green
Ground
Wire
Black
Wires
attach the two black wires and green (ground) wire to the
negative (-) battery post. (Figure 11.)
on the battery should face out. (Figure 12.)
Positive (+)
Figure 11
White
Wire