Table of Contents
Advertisement
9476 Assembly and Setup Instructions
1. Insert two M3.5 washers and two 10mm shoulder screws
2. The power packs for the printers are attached to the
1-24
into the sides of the printer as shown and tighten with a
screwdriver. (Figure 17.)
Station's top shelf. Insert the tabs on the power pack into
the slots of the battery well in the base of the printer.
Push down until the latch snaps into place. (Figure 18.)
Battery
Well
Figure 17
Figure 18
Shoulder
Screw
Power
Pack
Advertisement
Table of Contents
