Router Front Panel Leds - Patton electronics SL4020 User Manual

SmartLink 4020 User Manual
Note The SmartLink has automatic MDX (auto-crossover) detection and configu-
ration on all Ethernet ports. Any of the ports can be connected to a host or
hub/switch with a straight-through wired cable.
Connect to the Internet service provider.
5
CAUTION
Verify that the AC power cord included with your router is compatible with local standards. If it is not,
6
refer to "Contacting Patton for assistance"
power cord. Plug the power adapter into the 12V DC, 1.0A port on the SmartLink 4020. Connect the
other end of the power cord to an appropriate AC power outlet.
Wait 30 seconds after powering the SmartLink 4020 on, then verify that the green Power LED is lit (see
7
figure 3). At this point, you should be able to use your browser to surf the Internet.
Note
Follow the directions of your voice service provider to set up voice services.
Installing the router
The external router power supply automatically adjusts to accept
an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
on page 85 to find out how to replace it with a compatible
Figure 3. Router front panel LEDs
2 • SmartLink installation
24