Enable Auto Upgrade; Auto Upgrade Protocol; Upgrade Server; Auto Upgrade Url - Patton electronics SL4020 User Manual

Analog voip soho router

Hide thumbs Also See for SL4020:

Table of Contents

SmartLink 4020 User Manual

7 • System

Enable Auto Upgrade

Enable or disable auto upgrade—If enabled, the SmartLink 4020 will automatically check the upgrade server

on a periodic basis for new system firmware and software upon reload or power cycle.

Select the protocol for auto upgrade

Specify the auto upgrade server IP address

Specify the auto upgrade server by URL. This field is dependent on the auto upgrade service package installa-

tion. The default value is iadmgr.

When you are finished configuring settings, click the

button to save the changes.

Save AutoUpgrade

For both HTTP and TFTP methods, the device will reboot itself into the downloader mode if the main appli-

cation is executing, and proceed with the ROM file download and permanent write of the application to the

device's flash memory. During download of new firmware images, the LEDs on the SmartLink 4020 will flash

sequentially. Typically, HTTP downloads take about 5–10 minutes. After the download is completed, the

download status page will be displayed.

Figure 52. Manual Upgrade window

Manual Upgrade

Table of Contents

Smartlink 4020