Connecting The Power Supply; Router Front Panel Leds - Patton electronics SmartNode 4552 Getting Started Manual

SmartNode 4552 & 4562 Getting Started Guide

Connecting the power supply

Do the following to connect the power supply to the Model 4552:
Note
Do not connect the power cord to the AC power outlet at this time.
1. Insert the barrel-type connector end of the AC power supply into the 5V DC, 1.0A port (see
page 15).
2. Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to "Contacting Patton for assistance"
power cord.
3. Connect the male end of the AC power supply power cord to an appropriate AC power outlet.
4. Verify that the green Power LED is lit (see
Installing the gateway router
The external router power supply automatically adjusts to accept
an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
on page 37 to find out how to replace it with a compatible
Figure 6. Router front panel LEDs
figure 6).
3 • SmartNode installation
figure 2 on
26