Procedures Prior To Operation - Ko Propo EX-1 ASF Instruction Manual

■ Procedures Prior to Operation

1.Switching On
After ensuring that it is safe to do so, switch on the transmitter followed by the receiver.
This transmitter uses the DSSS method of communication on the 2.4GHz band for 2.4GHz
ASF Mini-Z and dNano only.
You can not use this with other types of systems.
2.Model Confirmation
Confirm the model which will be used.
3.Checking Movements
With the model's wheels lifted off the ground, operate transmitter to check for proper
movement. While driving, use steering and throttle trims to make fine adjustments. Drive in a
figure 8 pattern to check steering balance.
P
Use the [Quick Setup] function to easily arrange the initial settings.
P
See[Trim and Sub Trim Operation] on the following page.
4.Switching Off
After a driving session, switch off the receiver, followed by the transmitter. Remove the
battery pack from the model.
After switching off, wait at least 5 seconds before switching on again to ensure proper operation.
An alarm will sound if the controls are idle for **minutes. Operate the transmitter to stop the alarm.
Figure 8 Pattern
Stand
11
Trim