Throttle Reverse(Th-Reverce); Throttle Drag Brake(Th-Dragbrake); Brake Override(Brake Override) - Ko Propo EX-1 ASF Instruction Manual

Throttle Reverse(TH-Reverce)

This function reverses the throttle direction. This setting
screen is common with the steering.
Example
Use this function when, after installing the servo, movements
are the opposite of transmitter inputs (pulling the trigger to
accelerate forward results in reverse movement).
Setting Range ( :NOR)
Default
see [Steering Reverse]
STEERING:
THROTTLE:REV
(Reverse)
P For electric cars, the throttle is set by the ESC so there is no need
to set this function. However, some older ESCs will not function
properly unless reverse is also set.

Throttle Drag Brake(TH-DragBrake)

This function enables a light brake application at the
m o m e n t w h e n t h e t h r o t t l e p o s i t i o n c h a n g e s f r o m
acceleration to deceleration.
Example
Normally, the throttle would return to neutral when it is
released from acceleration. However, depending on the
type of vehicle or race, a light application of brake at this
moment may make driving easier.
Setting Range ( Default :OFF)
KEY:OFF, ET1 - 5, BT1
Assigns a key to be used to activate/deactivate the drag brake.
BRAKE:OFF, 0.5 - 50.0 {increments of 0.5}
Sets the amount of neutral brake.
If [BRAKE] is set to any value other than OFF, drag brake will be
P
activated. Drag brake can also be activated/deactivated via the
key assigned by [KEY].
P
[DBK] Display on the Function Monitor!
If [BRAKE] is not set to OFF, [DBK] will be displayed on the initial
screen's function monitor. If the key assigned to drag brake is
pressed while at the initial screen, [DBK] will disappear from the
function monitor.
, NOR
(Normal)

Brake Override(Brake Override)

Arrange another maximum brake setting, which can be
activated/deactivated by the ET lever or BT button.
Example
If a change in driving conditions is foreseen, the throttle
brake setting can be changed during driving.
Setting Range
KEY:OFF, ET1 - 5, BT1(
Assigns a key to be used to activate/deactivate the brake
override.
If brake override is deactivated, the throttle brake setting
will be activated.
BRAKE:0 - 100%(
Default
Sets the brake override's brake setting.
For detailed explanations of the brake function, refer to
[Throttle Brake].
P Like Travel Override, this function is used to change the brake
setting. If a change in driving conditions is foreseen, the throttle
brake setting can be changed during driving.
P
[BOR] Display on the Function Monitor!
If the key assigned to brake override is pressed, [BOR] will be
displayed on the initial screen's function monitor. If this key is
pressed while at the initial screen, [BOR] will disappear from the
function monitor.
28
:OFF)
Default
:100%)