Table of Contents
Advertisement
●Pairing
1.
Preparing the Transmitter
Switch on the transmitter.
Press the ENTER key at the startup screen. (Main
Menu display)
Use the jog dial to move the cursor to [System], then
press the ENTER key.
Move the cursor to [Pairing] on the System Menu
screen, then press the ENTER key.
Press the ENTER key.
Images of the transmitter and receiver will display
and the arrow flow can be checked. (In this state, the
transmitter is transmitting the pairing signal.)
●Pairing
After preparing the transmitter in the example to
the left, prepare the car receiver with the proce-
dure listed below.
While pressing setup button
about 1m
LED light up
release button
LED light down
Pairing is complete
Once pairing is complete, pressing the
ENTER key will exit the pairing screen
mode.
Turn off the power of the receiver and
turn it on again for operational use of the
vehicle.
10
Turn ON Power
LED light up
again
Advertisement
Table of Contents
