Flash Time - Panasonic KX-TA1232 Programming Manual

[413] Flash Time

Description
Assigns the length of the flash time. If your system is installed behind a host PBX or Centrex
line, External Feature Access (EFA) is necessary to obtain their services. To enable it, select a
required hooking signal sending time for the outside line group.
Selection
• Outside line group (TRG) number:
1 through 8,
( =all outside line groups)
• Time (milliseconds):
Disable (no EFA) / 80 / 96 / 112 / 200 / 300 / 400 / 500 / 600 / 700 / 800 / 900 / 1000 / 1100
/ 1200
Default
All outside line groups — 600 msec
Programming
1.
Enter 413.
Display: 413 FLASH TIME
2.
Press NEXT.
Display: TRK GRP NO?
3.
Enter an outside line group number.
To enter outside line group number 1, you can also press NEXT.
Display example: TRG1: 600 msec
4.
Keep pressing SELECT until the desired time is displayed.
5.
Press STORE.
6.
To program another outside line group, press NEXT or PREV, or SELECT and the desired
outside line group number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• You may disable EFA, if not required. The Flash feature will be in effect in place of EFA.
Program [414] Disconnect Time is used to select the time required for the Flash feature.
• The flash time required is determined by the central office or the host PBX lines.
• To assign all outside line groups to one selection, press the
display shows the contents programmed for outside line group 1.
Programming Guide
General Programming
key in step 3. In this case, the
127