Table of Contents
Advertisement
4. Locations and Functions
1
Lens mount of C-mount type. *1)
2
Interline-transfer CCD sensor.
3
Video output BNC connector
4
SW1 switch on the rear panel to set the shutter speed and other function modes.
5
6 pin connector for RS 232C signals, input of external trigger pulse and WEN output.
6
12 pin connector for DC +12V power external sync signals and output of video.
7
GAIN potentiometer for adjusting video level.
8
mounting holes 8 x M3deept5.
*1) Note:
Rear protrusion on C-mount lens must be less than 10.0mm (0.4 inch approx.)
When IR cut filter is used, it must be less than 7.0 mm (0.28 inch approx.)
The IR cut filter is placed in the C-mount thread.
The C-mount 25 mm IR cut filter must be ordered separately.
CV-M40
Fig. 1. Locations
- 3 -
Advertisement
Table of Contents
