Starter System; Troubleshooting; Voltage Drop Test; Starter Motor Removal / Disassembly - Polaris RANGER XP 700 4X4 Service Manual

STARTER SYSTEM

Troubleshooting

Starter Motor Does Not Run
• Battery discharged - Low specific gravity
• Loose or faulty battery cables or corroded connections
(see Voltage Drop Tests)
• Related wiring loose, disconnected, or corroded
• Poor ground connections at battery cable, starter motor
or starter solenoid (see Voltage Drop Tests)
• Faulty key switch
• Faulty kill switch
• Faulty Start Diode. Use a digital multi-meter to test
diode operation. Unplug the diode from the harness
and measure between the Orange and Orange/Green
diode connections. Continuity should flow one
direction only.
• Faulty starter solenoid or starter motor
• Engine problem - seized or binding (Can engine be
rotated easily?)
Starter Motor Turns Over Slowly
• Battery discharged - low specific gravity
• Excessive circuit resistance - poor connections (see

Voltage Drop Test)

• Engine problem - seized or binding (Can engine be
rotated easily?)
• Faulty or worn brushes in starter motor
Starter Motor Turns - Engine Does Not Rotate
• Faulty starter drive
• Faulty starter drive gears or starter motor gear
• Faulty flywheel gear or loose flywheel
Voltage Drop Test
The Voltage Drop Test is used to test for bad connections. When
performing the test, you are testing the amount of voltage drop
through the connection. A poor or corroded connection will
appear as a high voltage reading. Voltage shown on the meter
when testing connections should not exceed .1 VDC per
connection or component.
To perform the test, place the meter on DC volts and place the
meter leads across the connection to be tested. Refer to the
voltage drop tests on the starter system in this chapter.
Voltage should not exceed
.1 DC volts per connection

Starter Motor Removal / Disassembly

NOTE: Use electrical contact cleaner to clean starter
motor parts. Some solvents may leave a residue or
damage internal parts and insulation.
1. Remove the starter from the engine.
2. Remove the two bolts, washers, and sealing O-Rings.
Inspect O-Rings and replace if damaged.
NOTE: Note the alignment marks on both ends of
the starter motor casing. These marks must align
during reassembly.
ELECTRICAL
10
10.33